ZONE AMPLIFIER ZAA ZAA C AUTION AVIS 1 SAFETY INSTRUCTIONS 1 GENERAL USE (용도) 1 I NSTALLATIONS 2 F. Jedia JPAA/JPAA Amplifier Functions · JPAA Operating Instructions. Legislation and Compliance. RoHS Status: Not Applicable. Statement of. מגברי JDM היפרטרוניקס רכיבים וחלקי אלקטרוניקה מערכות כריזה והגברה מוצרי חשמל מגבר מיקסר חכם ל- 5 איזורי כריזה W. ZAA: A/A. ZAA: A/
|Published (Last):||21 March 2011|
|PDF File Size:||17.81 Mb|
|ePub File Size:||16.25 Mb|
|Price:||Free* [*Free Regsitration Required]|
Connect the power cord with safety after check of AC power. You had better use proper input ilevel. Install equipment as follow conditions. For phantom, please push phantom switch to supply with P.
ZAA, A havel been designed to use P. The corresponding LED indicator lights. Remote controller RC is prior to any other prioroty priority is activated, an signals are closed Az-1120a, P. Use LAN cable within m distance. It’s a community-based project which helps to repair anything.
The battery connection cord has to be 3. Second, you jdj increase input volume to the position “0” of LED indicator. This makes you replay, stop recorded message of the memory bank M1-M6 one time without setting repeat function. This is to prevent is to prevent mistake from remote controller RC Operation voltage for mic priority is DC 24V to the screw terminal.
מגברי JDM | מגבר מיקסר חכם ל- 5 איזורי כריזה W | היפרטרוניקס
When not using microphoneturn microphone “off”. Users can extend cable at 30m MAX. Keep in mind the following when connecting the apparatus.
Never block the air vents in the sides and front of the amplifier the following is figure of air-flow. Connect each connection of amplifier perfectly, if not, it maybe Caused hum, damage, electric shock in case of mis-connecting.
All signal output of remote controller RC will be closed under setting “on” of priority switch on the rear of P.
Amplifier P.A. 5 zone JDM ZA-1120A
The apparatus shall not be exposed to dripping or splashing and no object filled with liquids, such as vases, shall be place on the apparatus. Be sure rear of amplifier is securely mounted to rack.
Cable for audio line should be used by shield cable. Please pay close attention to the cooling requirements. Za–1120a all call switch, P.
T remote PTT level. If not, speaker may get harmful due to loud noise power by power shock. The following is priority ranking against all signal inputs of system and priority signal is “NO” “OFF” automatically. Pressing one of the zone button 1 to 5 delegates the signal to the desired loud speaker zone. T MIC signal can be activated is spite of priority. You can hear telephone ring Via speaker from other office in the night.
Then, attenuation function in the main amplifier are reset and zone power-out is converted to HI impedance power output. The stereo signal of the connected sound sources gets internally converted into a manual signal.
If clip indicator of output meter is turn-on, please turn GAIN control to the clock-otherwise for the optimum internal operstion.
All signals can be recorded but recording out can not be adjusted by master volume because recording output is in the front of circuit of master volume control. In case data are supplied to amplifier, send LED indicator lights. T MIC remote control.
This function is same as that of “TALK” or “message” operation. To prevent electric shock, do not open top cover. Maximum power output per zone speaker.